I notice in the App, that there is a field called SQ  Feet. It's this info needed if im setting everything.

I have checked in the smart schedule that tomorrow is programmed to run zones that should be skipped.

I have set up the whisperer to skip run if moisture is above 40%. Current moisture is:

• Zone 2 - 92%
• Zone 5 - 70%

Oggi è tutto il giorno che mi dice Offline... La connessione internet funziona correttamente... C'è qualche problema nel server? 

Hello - just a question about icons / symbols on the schedule.

Guessing the green tick means ‘success’, but what do the warning symbol, and the phone screen symbol mean?

Hi,

my firmware version is the 1.1.1

Please, can I have the last firmware vesion and the instructions for update my controller.

The serial number is E4956E4B6B05

Thank you

Why is my light flashing on my Netro?

Yard has been fertilized and need to water now as next scheduled is Sunday.

Hello everyone ,

During the last hour or so my netro spark has been doing these inexplicable Manual runs. They start and stop on their own without any manual input . Any ideas ?

Basically, is the Pixie water control valve one way, or can it shut off/turn on with pressure from either side?  In order to install it so the button faces up, I need to install it so the water comes in what is labeled as the "Outlet" side.  I don't know if it's labeled "Outlet" because it is a male connection, or because it cares about the direction of the water.  Otherwise, I will need to buy a male/male and female/female adapter, flip it "upside down" and use it with the button facing down.

Thanks.

After 4 months of non use over winter, I cannot restart my Netro system 

1 sec  blinking of light and have pressed reset button but still get  message “off line” and blinking persists.  

I have a good WiFi signal. 

Doesn't respect watering hours in smart mode.

The time of the zones has only been changed and it cannot be reset and it is watering every 5 minutes.

How can I reset any zone

Zones 12 Serial number E4956E4B65BD Hardware version 1.2 Firmware version 1.1.3 Last active 2021/04/05 20:11

How do I cancel a watering schedule while we make sprinkler repairs?

I am currently located in New Jersey. I just reseeded my back yard and lawn on Monday. How often should I water them and what times would you recommend 

I have a mister setup with multiple Herb racks and raised garden beds. I just got a Pixie and a few Whispers. My hope was using one Pixie and monitoring each bed with a whisper. Is this possible? Can I create multiple zones? Is this something going forward that might be possible? I don't want to set them up as standalones.

Due to external factors on our property it would be very useful to be able to set the current moisture level for a zone. Is there a way to do this ?

Ive been trying to remove/disable a zone however the app is not allowing me to do so.  Is there an alternatuve method?

I wanted to add a whisper sensor to my existing system.  I accidentally added it as a new device.  I did eventually add the new whisper sensor to my original device.  The issue is I now have two devices in the app.  The first is a device named Sprinkle that has my three whisper sensors attached and a second device named Plant Sensor with nothing attached to it. I want to delete the device  named Plant Sensor.  I cannot find a way to delete it.  

Thanks,

Scott

why do i get this error? I am trying to install in israel

Hi,

Is there a way for the App to notify me once irrigation has started or stopped? 

Thank you.

Regards,

Imran Ali