Wency Pan
Updated at 2023-12-11 02:00:48 UTC

Dear Mark,


I think what happened is that when you installed the controller you chose the sensor first and the app thought you have the intension to add some standalone sensors (not assigned to any zones in the controller).


To move the stand alone sensors to a zone, first you have to go to Settings->Sensors->Edit(upper right corner) and then delete the sensor. Next you will have to go to the home page. There is a drop down menu and please select your Pixie, then tap the "+" button on the upper right corner,  go to Add a Product-> Plant sensor and then complete the following procedures to add the sensor. You will need to press the button 6 times on the back of the sensor to change its mode to Setup mode (light blinking slowly).  


Sorry we did not receive your email. Are you sending it to support@netrohome.com?


Thanks,

Wency

Netro Support

View: 577    Like: 0


Mark Smith
2023-12-12 04:04:07 UTC  
So do I need to remove them and add them again?
Wency Pan
2023-12-12 06:36:23 UTC  
Hi Mark,

Yes you will need to remove the sensors and add them again.

Thanks,
Wency