I just installed the pixie timer and i would like to test it. 

However even if i scheduled two test runs, none of them appears in the schedule yet.  Is the schedule updated only once a day? 

Manual run is not available (the timer appears strike-out) so i cannot even test that way.

Thanks in advance for your help

Best 

 Jacopo

On my schedule screen sometimes I have an “!” mark. Sometimes it’s a “i” If I tap on the zone it takes me to preferences. Did I make a change that I am not aware of? What does this mean?  Thanks. 

Hello,

I’m trying to setup schedule for watering for next five months, But watering schedule shows only for two next months. I check the settings and I do have a selected five next month. is there something I’m not doing right?

Hello,

I can only add a maximum of 3 zones to my Whisperer Sensor. I wanted to add all my 6 zones to it? Is that possible? 

Thanks

I need to go outside to toggle this thing on off manually which defeats the purpose of having it.

Just go to last page, standard UX

Weeper hoses need to run for hours, the only option in smart scheduling is drip irrigation which is having it max out at like 30 mins a day 

Trying to add ISANREMO24 to PWS but I always get this error:

Please enter a valid ID !

Can you fix the problem or add for me:

ISANREMO24

My rain delay is set to 15 days. How do I reset or delete the current delay?

The program is now scheduled 15 days out, and I have disabled and re-enabled my program in hopes it would reset it. I checked restrictions and the delay is not listed.

Thanks!

Sensor was removed thru winter. Now will not activate and shows single red light only. Been in direct sun for 3 days so fully charged. Cannot get white light to reprogram.

Hello.
Is it possible to move a Zone, in my case: "Prato e back giardino" from Terminal 2 to Terminal 3 in a efficient way?
Let's say, for instance:  Copy Zone "Prato e back giardino" or Move "Prato e back giardino" from Terminal2 to Terminal 3, without being obliged to cancel the previous and reprogram all in a new Zone?

I've a problem with Terminal 2: the wire broke inside and I am not able to remove it ....

Thanx a lot
Gian Piero

I would LOVE to have a way to move a days scheduled run (and all subsequent runs) ahead XX days.  For example, if I have all my zones scheduled to run tomorrow, but it is raining today (and I'm scheduled for every third day runs), it would be great to move tomorrow's run ahead 2 days (as maybe it's not raining TOO hard, but enough to warrant not watering tomorrow), and then that move trigger all subsequent runs to move ahead by that many days as well.  Any plans for such a feature?

What does the  exclamation mark mean in the schedule pages?  Does this mean that they haven't run?? If so this is a major fail on the part of an irrigation system and should surely at the least result in notifications to the phone or email to alert?  I've had plants die in the last week of very dry weather as I assumed this was watering daily as per the advanced settings. s

With the Pixie is there a way in app (and if so where) to see if it skipped a day because either the sensor reported that the soil moisture was above the threshold set or because the weather provider predicted enough rain to cancel it?

Netro app says we received rain yesterday but it didn’t rain at all.  When I go to correct in app it only allows me to go as low as .1 inch.  How do I adjust to zero?

My pixie battery has failed after 1 season of use.  It doesn’t hold its charge, and therefore the timer goes off line.  How do I get a new one?

I was trying to see if there was a way to set a minimum moisture content for my grass. As in it can’t drop below 75% so that regardless of how much rain there is or Esther it had rabbits scheduled time or not it would run again or alert you that it needs watering?